Notifications
Clear all
Topic starter
February 12, 2021 2:12 pm
I am very new to this and am crawling through each step, I am at the point where I am going to be soldering the Temp probe non-isolated board. My question is do I solder the resistors? one? both? I know it may sound simple, but my level of expertise is 0.
February 12, 2021 2:23 pm
Can you provide links to the products you're referring to?
Mycodo Developer
Topic starter
February 12, 2021 2:41 pm
February 12, 2021 3:39 pm
These resistors are for pulling the SDA and SCL lines high (to 3.3 volts). The Raspberry Pi already has pull-up resistors, so there's no need to add any more.
Mycodo Developer